The short tape loop in the RE-100 still meant that you could only affect the delay so much. The RE-201 remedied this by using a longer tape loop that was spooled freely within a chamber with no reels. This loose spool approach resulted in less tape wear and fewer transient noises.
Because of their long, curvy waveforms, low frequencies experience phase attenuation more profoundly than other areas of the spectrum. You may want to high-pass your square wave so that it gives the bass line that extra grit without stepping on the feet of your sine’s big clear lows. Additionally, many producers like to make low-end seem fatter by using stereo widening effects. Use these carefully as the phase interactions between the low end of each stereo side can cause destructive interference. Use the mono/stereo switch on your DAW’s master track to check whether your low end survives when everything’s running through the center channel.
One of the best things about the drive to produce holiday albums is the way it sometimes brings musicians together and spurs interesting collaborations, like this unlikely musical two-some. Enjoy!
The same note, one octave up, appears in Fret 11 on the 1st string, but in order to get back to the previous D#/E♭, we have to skip one string and go back three frets this time (follow the top-right green arrow). This happens every time we cross the 2nd string, because of the tuning alteration. Obviously, we could have used another reference point, the note E an octave up, which appears in Fret 12 of the 1st string, but it helps to understand the relationship between the strings that cross the 2nd string.